Husqvarna 55 EPA I Chainsaw User Manual


 
38 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw model 55 Rancher. The combinations of power
head, bar and chain have been investigated in accordance with the kickback and vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also
achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Chain saw model Husqvarna 55 Rancher met the kickback performance requirements of ANSI B 175.1-2000 when tested with the
combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback saw chain
since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend to use only the listed
combinations of bars and chains for chain saw model Husqvarna 55 Rancher. Other chain saw models may not meet the kickback
requirements when equipped with the listed bar and chain combinations.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the
table below.
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13 0,325 0,050 10T Husqvarna H30 56
15 0,325 64
16 0,325 66
18 0,325 72
20 0,325 80
15 0,325 0,058 10T Husqvarna H21,
Husqvarna H25
64
16 0,325 66
18 0,325 72
20 0,325 80
18 3/8 0,058 11T Husqvarna H81 68
20 3/8 72
16 3/8 Husqvarna H42,
Husqvarna H48
60
18 3/8 68
20 3/8 72
24 3/8 84
0,050"/1,3 mm H30/95VP - - 20LP 20BP 33LG
- H80 - 72LP 72LG 76SL
0,058"/1,5 mm - H25,H21 S24 21LP 21BP 34LG
H42 H81 S48 73LP 73LG 77SL