Filter
Top Products
20 – English
MAINTENANCE
Troubleshooting schedule
Control panel
Troubleshooting takes place from the keypad.
Troubleshooting the battery and/or the battery charger during charging.
Battery
Battery charger
LED display Possible faults Possible action
Green activate LED flashing. Low battery voltage. Charge the battery
Error LED flashes. Overload.
The cutting attachment is jammed.
Release the cutting attachment.
Temperature deviation Allow the machine to cool down.
The power trigger and the activate
button are pressed at the same time.
Release the power trigger and the
machine is active.
The machine does not run Dirt in battery connectors.
Clean with compressed air or a soft
brush.
Error LED is lit with red light. Service Contact your service agent.
LED display Possible faults Possible action
Green activate LED flashing. Low battery voltage. Charge the battery
Error LED flashing Temperature deviation
Use the battery in surroundings
where temperatures are between -10
°C and 40 °C.
Over voltage
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Remove the battery from the battery
charger.
Error LED is lit Cell difference too much (1V) Contact your service agent.
LED display Possible faults Possible action
Error LED flashing Temperature deviation
Use the battery charger only when the
surrounding temperature is between 5
°C and 40 °C.
Error LED is lit Contact your service agent.