Husqvarna 536 LIR Trimmer User Manual


 
MAINTENANCE
English 21
Inspection and maintenance
All servicing and repair work on the machine requires
special training. This is especially true of the machine
s
safety equipment. If your machine fails any of the checks
described below you must contact your service agent.
When you buy any of our products we guarantee the
availability of professional repairs and service. If the
retailer who sells your machine is not a servicing dealer,
ask him for the address of your nearest service agent.
Only use original spare parts.
Regularly check that the battery charger and the battery
are intact.
Cleaning
Clean the machine after use. If the battery connector on
the machine is dirty, clean it by blowing them with
compressed air or use a soft brush.
Make sure the battery and battery charger are clean and
that the ter
minals on the battery and the battery charger
are always clean and dry before the battery is placed in
the battery charger.
Keep the battery guide tracks clean. Clean plastic parts
with a clean and dr
y cloth.
Trimmer line
Check the line by threading it into the hole on the cover,
as shown in the illustration.
Only use the recommended trimmer heads and trimmer
lines
. These have been tested by the manufacturer to suit
a particular motor size. This is especially important when
a fully automatic trimmer head is used. Only use the
recommended cutting attachment. See the chapter on
Technical data.
Trimmer head
Check that the trimmer head is undamaged and not
cracked. Replace the trimmer head if necessary.
Press the snap-in clips on the trimmer head and
remove the trimmer head and line.
Pull out the line chute assembly.
Remove the nut holding the trimmer head and the
drive disc.
Replace the trimmer head.
Install the drive disc and the trimmer head.
Fit the nut and the line chute assembly.
Fit the trimmer head.
!
WARNING! Always remove the battery
before any maintenance on the machine.
IMPORTANT! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
Li-ion
Li-ion