Filter
Top Products
English – 37
MAINTENANCE
Heated handles
(372XPG)
On models with the designation XPG/G, the front as well as
the rear handle are equipped with electric heating coils.
These are fed with electrical current from an integrated
generator in the chain saw.
When the red mark on the switch is visible, the heating is on.
Electrical carburetor heating
(372XPG)
On models with the designation CARBURETOR HEATING
there is an electrically heated carburetor. Electrically powered
heating prevents ice formation in the carburetor. A thermostat
regulates the heating so that the carburetor always has the
right working temperature.
Canada
If this chain saw has the model code XPG/G then it is
equipped with an electrically heated carburettor. The
electrical heating prevents icing in the carburettor. A
thermostat regulates heating so that the carburettor always
has the correct working temperature.
Other countries
The carburettor heater is used in the following temperature
range: ±0ºC or colder. During high humidity, icing of the
carburettor can occur earlier than specified.
The carburettor heater only heats the carburettor when the 3-
way switch is set to position ”II”.
The switch is off in position ”0”, supplies current to the handle
heater in position ”I”, supplies current to the carburettor in
position ”II”.
CAUTION! The carburettor heater reaches maximum
temperature after about 3 minutes. It is therefore important
that the machine is not run for longer with the heater switched
on. If the switch is left on for too long the carburettor will
overheat and lead to running problems or starting problems.