Filter
Top Products
20 – English
SAFETY INSTRUCTIONS
The log is supported at both ends. There is a high risk that
the chain will jam.
Start by cutting from above (about 1/3 of the way through).
Finish by cutting from below so that the two cuts meet.
Limbing
When limbing thick branches you should use the same
approach as for cutting.
Cut difficult branches piece by piece.
Tree felling technique
Safe distance
The safe distance between a tree that is to be felled and
anyone else working nearby is at least 21/2 tree lengths.
Make sure that no-one else is in this ”risk zone” before or
during felling.
Felling direction
The aim is to fell the tree in a position where you can limb and
cross-cut the log as easily as possible. You want it to fall on
ground where you can stand and move about safely. The main
point to avoid is letting the tree fall onto another tree. See
instructions under the heading Freeing a tree that has fallen
badly.
Once you have decided which way you want the tree to fall
you must judge which way the tree would fall naturally.
Several factors affect this:
• Lean of the tree
• Bend
• Wind direction
• Arrangement of branches
• Weight of snow
You may find you are forced to let the tree fall in its natural
direction because it is impossible or dangerous to try to make
it fall in the direction you first intended.
Another very important factor, which does not affect the felling
direction but does affect your safety, is to make sure the tree
has no damaged or dead branches that might break off and
hit you during felling.
Clearing the trunk and preparing your retreat
Remove any branches that are in the way. To do this it is best
to work from the top down and keep the trunk between you
and the chain saw. Never limb above shoulder height.
!
WARNING! It takes a lot of experience to fell
a tree. Inexperienced users of chain saws
should not fell trees. Do not attempt any task
that you feel unsure of!
1
2
3
!
WARNING! During critical felling operations,
hearing protectors should be lifted
immediately when sawing is completed so
that sounds and warning signals can be
heard.