Filter
Top Products
English – 37
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
Bar Chain
Length, inches Pitch, inch Max nose radius
15 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
16 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
18 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
20 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
24 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
28 3/8 11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
0,050"/1,3 mm 72LP 72LG 72V
0,058"/1,5mm H42/73LP EM S48/73LG 73V
0,063"/1,6 mm 75LP 75LG 75V
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries to the
user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized
training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always
use the safest saw and cutting equipment applicable to your cutting need.
L
_
D