Filter
Top Products
30 – English
Starter device
WARNING!
• When the recoil spring is assembled in the starter
housing, it is in tensioned position and can when
treated carelessly, pop out and cause injuries.
• Always be careful, when changing the recoil spring or
the starter cord. Always wear safety goggles for eye
protection.
!
MAINTENANCE
Changing a broken or worn
starter cord
• Loosen the screws, that
hold the starter device
against the crankcase and
remove the starter device.
• Pull out the cord approx. 30
cm and lift it up into the
notch in the pulley. Zero-set
the recoil spring by letting
the pulley rotate slowly
backwards. Undo the screw
in the centre of the pulley
and remove the pulley.
• Insert and fasten a new
starter cord in the pulley.
Wind approx. 3 turns of the
starter cord on to the pulley.
Assemble the starter pulley
against the recoil spring, so
the end of the spring
engages to the pulley. Fit
the screw in the centre of
the pulley. Carry the starter
cord through the hole in the
starter housing and the
starter handle. Make a knot
on the starter cord.
Tensioning the recoil spring
• Lift the starter cord up in the
notch on the starter pulley
and turn the starter pulley 2
turns clockwise.
NOTE! Check that the
starter pulley can be turned
at least half a turn, when the
starter cord is entirely pulled
out.
Starter device assembly
• Assemble the starter
device, by pulling the starter
cord out first, then place the
starter against the
crankcase. Then slowly
release the starter cord so
that the pulley engages with
the pawls.
• Assemble and tighten the
screws, which hold the
starter.
Changing the broken recoil spring
• Lift the starter pulley (see
"Changing a broken or worn
starter cord"
). Bear in mind
that the return spring sits
under tension in a cassette.
• Dismantle the cassette with
the return spring from the
starter.
• Lubricate the recoil spring
with thin oil. Assemble the
cassette with return spring
in the starter. Fit the starter
pulley and tension the return
spring.