Filter
Top Products
38 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 340, 340e, 345e and 350. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and vibration
requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a hard nose.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also
achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Chain saw models Husqvarna 340, 340e, 345e and 350 met the kickback performance requirements of ANSI B 175.1-2000 when
tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend to use only
the listed combinations of bars and chains for chain saw models Husqvarna 340, 340e, 345e and 350. Other chain saw models
may not meet the kickback requirements when equipped with the listed bar and chain combinations.
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13 0,325 0,050 10T
Husqvarna H30
56
15 0,325 0,050 10T 64
16 0,325 0,050 10T 66
18 0,325 0,050 10T 72
20 0,325 0,050 10T 80
13 0,325 0,058 10T
Husqvarna H25
56
15 0,325 0,058 10T 64
16 0,325 0,058 10T 66
18 0,325 0,058 10T 72
20 0,325 0,058 12T 80
0,050" H30
0,058” H25