Filter
Top Products
GENERAL SAFETY PRECAUTIONS
English – 15
115 09 86-95 Rev.2 2007-11-27
• Raise the tip of the bar and stretch the chain by
tightening the chain tensioning screw using the
combination spanner. Tighten the chain until it does
not sag from the underside of the bar.
• Use the combination spanner to tighten the bar nuts
while lifting the tip of the bar at the same time. Check
that you can pull the chain round freely by hand and
that it does not sag from the underside of the bar.
The position of the chain tensioning screw on our chain
saws varies from model to model. See instructions under
the heading What is what? to find out where it is on your
model.
345e
• Release the knob by folding it out.
• Turn the knob anti clockwise to loosen the bar cover.
• Adjust the tension on the chain by turning the wheel
down (+) for tighter tension and up (-) to loosen the
tension.
• Tighten the bar clutch by turning the knob clockwise.
• Fold the knob back in to lock the tensioning.
Lubricating cutting equipment
Chain oil
Chain oil must demonstrate good adhesion to the chain
and also maintain its flow characteristics regardless of
whether it is warm summer or cold winter weather.
As a chain saw manufacturer we have developed an
optimal chain oil which has a vegetable oil base. We
recommend the use of our own oil for both maximum
chain life and to minimise environmental damage. If our
own chain oil is not available, standard chain oil is
recommended.
!
WARNING! Poor lubrication of cutting
equipment may cause the chain to snap,
which could lead to serious, even fatal
injuries.