Filter
Top Products
English – 45
TANK UNIT
WARNING!
The fuel used in the chain saw has the follow-
ing hazardous properties:
• The fluid and its vapour are poisonous.
• Can cause skin irritation.
• Is highly inflammable.
Assembly
Assemble the following parts:
1. Fit the engine unit from the clutch side and at the same
time move the oil hose (E).
4. Fit the bolt (A), the bolts (F), the guard (D) and the impulse
hose (B).
Assemble the following parts:
5. Fit the ignition system and the spark plug. See the chapter
"Ignition system".
6. Fit the starter. See the chapter "Starter".
7. Fit the carburettor. See the chapter "Carburettor".
8. Fit the muffler. See the chapter "Safety equipment".
9. Assemble the centrifugal clutch. See the chapter "Centrifu-
gal clutch".
10. Assemble the chain and bar. See the Operator Guide.
After assembly is complete, refuel and test run the chain saw.
See the Operator Guide.
3. Fit the chain catcher and the bolts (C).
2. Grab the intake manifold through the hole in the tank unit
using flat pliers and carefully pull it up.
D
F
C
C
A
B
F
F