Filter
Top Products
20 cm
5 cm
30 cm
GETTInG sTarTED WITH
Husqvarna’s rObOTIC laWnMOWEr
1. Open the connectors and lay the wire ends in the recesses
on each connector.
2. Press the connectors together using a pair of pliers.
3. Cut off any surplus boundary wire. Cut 1 to 2 cm above
the connectors.
4. Press the connectors onto the contact pins, marked A, on
the charging station. It is important that the right-hand
wire is connected to the right-hand contact pin, and the
left-hand wire to the left-hand pin.
1. Narrow passages in the garden make it difcult for the
robotic lawnmower to nd the charging station. The
robotic lawnmower can be lead to remote garden areas
using the guide wire. The guide wire also helps the
robotic lawnmower to quickly nd the charging station.
2. Lay the guide wire under the charging station and at
least 2 metres straight out from the front edge of the
charging station.
3. Run the guide wire to the point on the boundary wire
the connection will be made. Avoid laying the wire at
tight angles.
4. Cut the boundary wire with a wire cutters at the centre
of the eyelet that was made in step 2.3.
5. Connect the guide wire to the boundary wire using the
accompanying couplers. Press the coupler completely
together with a pair of pliers.
6. Fit a connector to the other end of the guide wire. Fasten
the connector to the contact pin marked G1 on the
charging station.
plaCEMEnT Of anD COnnECTInG
THE CHarGInG sTaTIOn
CHarGInG THE baTTEry anD plaCEMEnT
Of THE bOunDary WIrE
See chapters 3.3 and 3.4 in the Operator’s Manual.
See chapter 3.2 in the Operator’s Manual.
1. Place the charging station at a central position in the
working area, with a lot of open space in front of the
charging station and on a relatively horizontal surface.
2. Connect the transformer’s low voltage cable to the
charging station and the transformer.
3. Connect the transformer to a 230 V wall socket.
1. Place the robotic lawnmower in the charging
station to charge the battery while the boundary
wire is laid. Set the main switch to position 1.
2. Lay the boundary wire so that it forms a loop
around the working area.
3. Make an eyelet at the point where the guide wire
will be connected later (see step 4.5).
Charging station
Transformer Low voltage cable Boundary wire and couplers Pegs Connectors Measurement gauge
COnnECTInG THE bOunDary WIrE
See chapter 3.5 in the Operator’s Manual.
plaCEMEnT Of anD COnnECTInG
THE GuIDE WIrE
See chapter 3.6 in the Operator’s Manual.
1. Main switch
2. STOP button
3. Charging strip
4. LED for function check of the
boundary and guide wires
5. Display
6. Keypad
0 cm/0”
10 cm/4”
35 cm/14”
min 2 m/7 ft
min 30 cm/12”
30 cm/12”
10 cm/4”
3
4
1
2
2
5
7
2
2
3
2
13
3
3
4
21
5
6
1
2
3
3
4