Husqvarna 330X Lawn Mower User Manual


 
Husqvarna auTOMOWEr
®
320/330X
quICK GuIDE
www.automower.com
115 49 25-26
Adjusting the robotic lAwnmower to suit
the size of your lAwn
The mowing results depend on mowing time. Adjust the
mowing time to suit your garden using the Timer function.
If the robotic lawnmower cuts too much: The lawn will
look trampled.
If the robotic lawnmower cuts too little: The lawn will not
be properly mown.
timer
test docking
1. It is important that the robotic lawnmower can easily dock
with the charging station to ensure safe operation. Use the
Installation > Find charging station > Overview > Test function to
test this. If the robotic lawnmower has difculty docking,
the position of the charging station must be reviewed.
See chapter 3.2 in the Operator’s Manual.
test Accessibility
2. Narrow passages in the garden make it difcult for the
robotic lawnmower to nd the charging station. Use the
Installation > Lawn coverage > Overview > Test function to test
that the robotic lawnmower can travel through the
narrowest passage. If the test fails, the position of the guide
wire must be reviewed and possible manual setting changes
made. See chapters 3.6 and 6.8 in the Operator’s Manual.
TEsT DOCKInG anD aCCEssIbIlITy
See chapters 3.6 and 6.8 in the Operator’s Manual.
Here you can nd a number of tips relating to the positioning of the guide wire in narrow passages as well as
settings for the mower’s behaviour in narrow passages.
aDjusTInG THE rObOTIC laWnMOWEr
TO suIT yOur GarDEn
See chapter 6 in the Operator’s Manual.
Here you will nd some tips on important settings for your robotic lawnmower.
All settings for your robotic lawnmower are made via the menu functions.
You decide what times during the day the robotic lawnmower
is to work. The robotic lawnmower mows about 135 m² per
hour and day (approx. 90 m² for Automower® 320). For
example; if your garden consists of 1,200 m² of lawn, the
robotic lawnmower should work on average 9 hours per day
(13 hours for Automower® 320).
AUTOMOWER
®
is a trademark owned by Husqvarna AB. Copyright © 2013 HUSQVARNA. All rights reserved.
sTarTInG anD sTOppInG
See chapters 4.3 and 4.4 in the Operator’s Manual.
stArting
1. Open the hatch by pressing the STOP button.
2. Set the main switch to position 1. When you do this for
the rst time, a start up sequence starts where you select
a four digit PIN code among other things.
3. Press the START button.
4. Close the hatch.
stopping
Press the STOP button.
1
2
6
7
5
3