Husqvarna 327LDX-series Brush Cutter User Manual


 
ASSEMBLY
10 – English
Fitting the loop handle
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
Slide the spacer into the slot in the loop handle. Fit the
nut, knob and screw. Do not overtighten.
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
Assembly:
Loosen the coupling by turning the knob.
Align the tab of the attachment (A) with the arrow on
the coupling (B).
Push the attachment into the coupling until the
attachment snaps into place.
Before using the unit, tighten the knob securely.
Dismantling:
Loosen the coupling by turning the knob (at least 3
times).
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
A
B
C