Filter
Top Products
ASSEMBLY
English – 11
Fitting the hand guard and loop
handle
(327HDA65, 327HE3)
1 Slide the spacer into the slot in the loop handle.
2 Fit the nut and screw. Do not overtighten.
3 Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION! The loop handle and hand guard must not
be fitted behind the arrow marked on the shaft.
Fitting the handle
(327HE3, 327HE4)
Fit the handle using two screws.
Fitting the cutting head
(327HDA65)
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1 Fit the cutting head to the shaft. CAUTION! Make sure
the drive shaft inside the shaft engages with the
recess in the cutting head.
2 Tighten the lower screw first, then the upper screw.
Adjusting the harness
(327HE4)
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
1 Put on the harness.
2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support
hook is roughly level with your right hip.