Filter
Top Products
English
–
3
CONTENTS
Contents
Note the f
ollowing before starting:
Please read the oper
ator’s manual carefully.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
This engine label certifies that the product is certified in
accordance with American exhaust emissions requirements
EPA Ph II and Californian exhaust and evaporative emissions
requirements CARB Tier III. The Emissions Compliance
Period referred to on the emissions compliance label
indicates the number of operating hours for which the engine
has shown to meet Federal and Californian emission
requirements.
Category C = 50 hours, B = 125 hours, and A = 300 hours.
KEY
TO SYMBOLS
Symbols
....................................................................... 2
CONTENTS
Contents
...................................................................... 3
Note the following before starting: ................................ 3
INTR
ODUCTION
Dear customer!
............................................................ 4
WHA
T IS WHAT?
What is what?
.............................................................. 5
GENERAL SAFETY PRECA
UTIONS
Impor
tant ...................................................................... 6
Personal protective equipment ..................................... 6
Machine
′
s safety equipment ........................................ 7
ASSEMBL
Y
Fitting the cutting head
................................................ 14
Fitting the bar and chain .............................................. 14
Adjusting the harness .................................................. 14
Filling with oil ................................................................ 14
Assembling and dismantling the two-piece shaft ......... 14
Fitting the impact guard ............................................... 15
Assembly of the saw attachment ................................. 15
FUEL HANDLING
Fuel saf
ety ................................................................... 16
Fuel .............................................................................. 16
Fueling ......................................................................... 17
ST
ARTING AND STOPPING
Chec
k before starting ................................................... 18
Starting and stopping ................................................... 18
W
ORKING TECHNIQUES
Gener
al working instructions ....................................... 20
MAINTENANCE
Carb
uretor .................................................................... 23
Muffler .......................................................................... 24
Cooling system ............................................................ 25
Spark plug .................................................................... 25
Two-piece shaft ........................................................... 25
Air filter ......................................................................... 25
Maintenance schedule ................................................. 27
TECHNICAL D
ATA
T
echnical data .............................................................. 28
FEDERAL AND CALIFORNIA EMISSIONS
CONTROL WARRANTY STATEMENT
Y
OUR WARRANTY RIGHTS AND OBLIGATIONS ..... 30
!
W
ARNING! Long-term exposure to noise can
result in permanent hearing impairment. So
always use approved hearing protection.
!
W
ARNING! Under no circumstances may the
design of the machine be modified without
the permission of the manufacturer. Always
use genuine accessories. Non-authorized
modifications and/or accessories can result
in serious personal injury or the death of the
operator or others.
Your warranty does not cover damage or
liability caused by the use of non-authorized
accessories or replacement parts.
!
W
ARNING! A pole saw is a dangerous tool if
used carelessly or incorrectly and can cause
serious, even fatal injuries. It is extremely
important that you read and understand the
contents of this Operator’s Manual.