Husqvarna 326LDX Trimmer User Manual


 
10 –
English
ASSEMBLY
Fitting the loop handle
(326C)
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
Fit the screw, securing plate and wing nut as shown in the
diagram.
Tighten the wing nut.
Fitting the loop handle
(326L, 326Lx, 326LDx)
Clip the loop handle onto the shaft. Note that the loop
handle must be tted between the arrows on the shaft.
Slide the spacer into the slot in the loop handle.
326L: Fit the nut, washer and screw.
326LX/326LDX: Fit the nut, knob and screw. Do not
overtighten.
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
(326LDx)
Assembly:
Make sure the knob is loose.
Align the cut-out in the lower part of the shaft with the
coupling locking tab on the upper part of the shaft. Then
lock the sections together.
Tighten the knob.
Dismantling:
Undo the knob (at least three turns).
Push the knob towards the coupling.
Carefully twist the lower half of the shaft to unlock it.
Hold both parts of the shaft and pull the lower part of the
shaft out of the coupling.