Filter
Top Products
MAINTENANCE
English – 25
1151020-95 Rev. 2 2008-03-10
Lubricating the flexible drive
shaft (326Ex)
Inside the hollow drive shaft of the edger is a flexible drive
shaft. This flexible drive shaft should be regularly
lubricated every 25 hours in operation. Loosen the two
screws on the angle gear and remove it. The flexible drive
shaft is easily removed from the hollow shaft by taking a
firm grip on the shaft end. Lubricate the entire length of
the flexible drive shaft and reinsert it in the hollow drive
shaft. Turn the shaft while inserting it so that it correctly
engages in the clutch. Refit the angle gear on the hollow
drive shaft and tighten the two screws.
Adjusting the edger’s cutting
depth (326Ex)
The cutting depth must be adjusted before starting work.
• Loosen the locking knob (A) and rotate the guard by
mo
ving the locking knob forwards or backwards. If the
locking knob is moved forwards (away from the
machine) the cutting depth is increased. If the locking
knob is moved backwards (towards the machine) the
cutting depth is reduced.
• Set the desired cutting depth.
• Lock the locking knob.
Adjusting the edger’s cutting
depth (326ES)
The cutting depth must be adjusted before starting work.
• Loosen the wing nut.
• Set the desired cutting depth.
• Tighten the wing nut.
A
CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.