Filter
Top Products
12 – English
ASSEMBLY
Assembly of the trimmer head
!
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter
“Technical
data”
. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
Assembling the loop handlebar
(326L, 326L
X-series
)
Assembling the loop handlebar
(326C)
• Clip the loop handle onto
the shaft. Note that the
loop handle must be fitted
between the arrows on the
shaft.
• Slide the spacer into the
slot in the loop handle.
• 326L
X-series
: Fit the nut,
knob and bolt. Do not
overtighten.
• Now adjust the trimmer to
give a comfortable working
position. Tighten the bolt/
knob.
• Position the handle on the
shaft. Note that the handle
must be mounted below
the arrow on the shaft.
• Fit the bolt, securing plate
and wing nut as shown in
the diagram.
• Tighten the wing nut.
It is extremely important that
the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.