Husqvarna 325HS99X Trimmer User Manual


 
12 English
STARTING AND STOPPING
Check before starting
Inspect the working area. Remove any objects that could
be thrown out.
Check the cutting attachment. Never use blades that are
dull, cracked or damaged.
Check that the machine is in perfect working order. Check
that all nuts and screws are tight.
Make sure the gear housing is lubricated correctly. See
instructions under the heading Gear housing.
Check that the cutting attachment always stops when the
engine is idling.
Only use the machine for the purpose it was intended for.
Make sure that the handle and safety features are in good
working order. Never use a machine that lacks a part or
has been modied outside its specications.
All covers must be correctly tted and undamaged before
you start the machine.
Starting and stopping
Starting
Cold engine
Ignition: Set the stop switch to the start position.
Choke: Set the choke control in the choke position. The
choke position is also the automatic start throttle position.
Air purge: Press the air purge diaphragm repeatedly until
fuel begins to ll the diaphragm. The diaphragm need not be
completely lled.
!
WARNING! The complete clutch cover and
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
Always move the machine about 3 metres
from the refuelling position before starting.
Place the machine on a firm surface.
Remember that the blades may start to move
when the engine is started. Make sure the
blades cannot come into contact with any
object. Make sure that no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury.
A