Husqvarna 324LX Trimmer User Manual


 
English
– 7
SAFETY INSTRUCTIONS
Muffler
Never use a machine that has a faulty muffler.
Regularly check that the muffler is securely attached to
the machine.
The muffler on your machine is equipped with a spark
arrestor mesh, this should be cleaned regularly. A blocked
mesh will cause the engine to overheat and may lead to
serious damage.
Never use a muffler with a defective spark arrestor mesh.
Cutting equipment
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be replaced.
Locking nut
When fitting, tighten the nut in the opposite direction to the
direction of rotation of the cutting attachment. To remove
it, undo the nut in the same direction as the cutting
attachment rotates. (CAUTION! The nut has a left-hand
thread.)
Tighten the nut using the socket spanner. 35-50 Nm (3.5-
5 kpm).
CAUTION!
The nylon lining inside the locking nut must not be
so worn that you can turn it by hand. The lining should offer a
resistance of at least 1.5 Nm. The nut should be replaced
after it has been put on approx. 10 times.
Cutting equipment
Trimmer head
Only use the recommended trimmer heads and trimmer
cords. These have been tested by the manufacturer to suit
a particular engine size. This is especially important when
a fully automatic trimmer head is used. Only use the
recommended cutting attachment. See the chapter on
Technical data.
!
WARNING! Never use a machine with faulty
safety equipment. The machine’s safety
equipment must be checked and maintained
as described in this section. If your machine
fails any of these checks contact your
service agent to get it repaired.
IMPORTANT!
This section describes how to choose and maintain your
cutting equipment in order to:
Reduce the risk of blade thrust.
Obtain maximum cutting performance.
Extend the life of cutting equipment.
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Refer to the instructions for the cutting attachment to check
the correct way to load the cord and the correct cord
diameter.