Filter
Top Products
1
2
3
4
5
6
7
20 cm
5 cm
30 cm
GE T TI NG STARTE D WI TH
HU SQVAR NA’ S ROBOTI C L AWN MOWER
1. Open the connectors and lay the wire ends in the recesses
on each connector.
2. Press the connectors together using a pair of pliers.
3. Cut off any surplus boundary wire. Cut 1 to 2 cm above
the connectors.
4. Press the connectors onto the contact pins, marked A, on
the charging station. It is important that the right-hand
wire is connected to the right-hand contact pin, and the
left-hand wire to the left-hand pin.
1. Run the guide wire through the slot at the bottom of the
charging station.
2. Fit the connector to the guide wire in the same way as for
the boundary wire, according to the instructions above.
3. Fasten the connector to the contact pin marked Guide on
the charging station.
4. Lay the guide wire at least 2 metres straight out from the
front edge of the charging station.
5. Run the guide wire to the point on the boundary loop
the connection will be made. Avoid laying the wire at
tight angles.
6. Cut the boundary wire with a wire cutters at the centre of
the eyelet that was made in step 2.3.
7. Connect the guide wire to the boundary wire using the
accompanying couplers. Press the couplers completely
together with a pair of pliers.
PLACEMENT OF AND CONNECTING THE CHARGING STATION
See chapter 3.2 in the Operator’s Manual.
CHARGING THE BATTERY AND PLACEMENT
OF THE BOUNDARY WIRE
See chapters 3.3 and 3.4 in the Operator’s Manual.
1. Place the charging station at a central position in the
working area, with a lot of open space in front of the
charging station and on a relatively horizontal surface.
2. Connect the transformer’s low voltage cable to the
charging station and the transformer.
3. Connect the transformer to a 230 V wall socket.
1. Place the robotic lawnmower in the charging
station to charge the battery while the boundary
wire is laid. Set the main switch to position 1.
2. Lay the boundary wire so that it forms a loop
around the working area.
3. Make an eyelet at the point where the guide wire
will later be connected. See step 4.5.
Charging station Transformer Low voltage cable Boundary wire and
couplers
Staples Connectors Measurement
gauge
CONNECTING THE BOUNDARY WIRE
See chapter 3.5 in the Operator’s Manual.
PLACEMENT OF AND CONNECTING
THE GUIDE WIRE
See chapter 3.6 in the Operator’s Manual.
1. Main switch
2. STOP button
3. Charging strip
4. LED for function check of the
boundary and guide wires
5. Cutting height indication
6. Display
7. Keypad
0 cm / 0"
5 cm / 2"
30 cm / 12"
min 2 m / 7 ft
20 cm / 8"
10 cm / 4"
3
4
1
2
4
1
1
7
2
1
3
3
3
4
21