Filter
Top Products
70 - English
9. TROUBLE SHOOTING
Outside working area If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence,
reinforcement bar) or buried cables in
the vicinity.
Try moving the boundary wire.
The working area slopes too much. Check that the boundary wire has
been routed correctly.
The boundary wire has been routed
the wrong way around an island.
Check that the boundary wire has
been routed in accordance with the
installation instructions.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has
been routed correctly.
Low battery voltage Automower
®
cannot find the charging
station.
Change the search settings
according to the Follow loop in (3-2-2)
on page 53.
Change the position of the charging
station.
The battery is spent. Expected life is 1 - 4 years. Contact
your dealer to replace the battery.
Wrong PIN code Wrong PIN code has been entered.
Three attempts are permitted, the
keypad is then blocked for five
minutes.
Enter the correct PIN code.
PIN code expired The Time lock (4-1-2) function has
been activated because the selected
number of days has expired.
This is normal. Enter the correct PIN
code.
Anti-theft protection in the GPS
module has been activated because
the mower is outside the anti-theft
area.
Return the mower to the anti-theft
area and enter the correct PIN code.
If the message is displayed in the
intended working area, the anti-theft
area radius needs to be increased.
No drive Automower
®
has got caught in
something.
Free the mower and rectify the
reason for the lack of drive. If it is due
to wet grass, wait until the lawn has
dried before using the mower.
The working area includes a steep
slope.
Maximum guaranteed slope is 35%.
Steeper slopes should be isolated.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope.
No contact in charging
station
Automower
®
makes poor contact with
the contact strips in the charging
station.
Check that Automower
®
has docked
correctly in the charging station.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and Automower
®
has made a number
of charging attempts.
Place Automower
®
in the charging
station and check that the charging
strips and contact strips make good
contact.
An object is obstructing Automower
®
. Remove the object.
Fault message Cause Action