Husqvarna 245R Trimmer User Manual


 
30 English
MAINTENANCE
Air lter
The air lter must be regularly cleaned to remove dust and dirt
in order to avoid:
Carburettor malfunctions
Starting problems
Loss of engine power
Unnecessary wear to engine parts.
Excessive fuel consumption.
Clean the lter every 25 hours, or more regularly if conditions
are exceptionally dusty.
Cleaning the air lter
240R, 245R/RX
Remove the air lter cover and take out the lter. Wash it
clean in warm, soapy water. Ensure that the lter is dry before
retting it.
If the machine is used in dusty conditions the air lter should
be soaked in oil. See instructions under the heading Oiling the
air lter.
250R, 252RX
Remove the air lter cover and remove both lters, A and B.
A is an air lter and B is a pre-lter. Both must be washed in
warm soapy water and dried. Filter A must then be soaked in
oil, see instructions under the heading Oiling the air lter.
265RX
Remove the air lter cover and take out the lter. Wash it
clean in warm, soapy water.
Ensure that the lter is dry before retting it.
Oiling the air lter
Always use HUSQVARNA lter oil, art. no. 531 00 92-48. The
lter oil contains a solvent to make it spread evenly through
the lter. You should therefore avoid skin contact.
Put the lter in a plastic bag and pour the lter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the lter inside the plastic bag and pour off
the excess before tting the lter to the machine. Never use
common engine oil. This would drain through the lter quite
quickly and collect in the bottom.
An air lter that has been in use for a long time cannot be
cleaned completely. The lter must therefore be replaced with
a new one at regular intervals. A damaged air lter must
always be replaced.
Bevel gear
The bevel gear is lled with the right quantity of grease at the
factory. However, before using the machine you should check
that the bevel gear is lled three-quarters full with grease. Use
HUSQVARNA special grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
B
A