Husqvarna 232R, 235R, 235FR Brush Cutter User Manual


 
12 – English
ASSEMBLY
Fitting the handlebar (232R)
Remove the screw at the rear of the throttle handle.
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
Align the screw hole in the throttle handle with the hole in
the handlebar.
Refit the screw in the hole in the rear of the throttle handle.
Screw the screw through the handle and handlebar.
Tighten it.
Unscrew the knob from the handlebar mounting.
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness. Tighten the knob.
Fitting the handlebar (235R, 235FR)
Remove the screw at the rear of the throttle handle.
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
Align the screw hole in the throttle handle with the hole in
the handlebar.
Refit the screw in the hole in the rear of the throttle handle.
Screw the screw through the handle and handlebar.
Tighten it.
Remove the mounting components from the handlebar
mounting.
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
Fit the wiring as shown.
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness. Tighten the knob.