Filter
Top Products
12 – English
Assembling the loop handlebar
ASSEMBLY
• Unscrew the handle and
plastic cover from the
handlebar bracket.
• Place the loop handlebar
with the handlebar holder
on the handlebar bracket.
Fit the handle and plastic
cover. Do not tighten too
tight.
• Put on the harness and
hang the trimmer in the
suspension hook. Now
finely adjust so that the
trimmer gives a
comfortable working
position when it‘s attached
to the harness. Tighten the
handle.
(225L Lite is not equipped
with a harness)
225L Lite
Assemble the loop handle by
pressing it on the shaft,
between the arrows. Place the
spacer (A) in the slot as
shown. Assemble the nut (B)
and the handle adjustment
screw (C) and tighten it.
Assembling:
• Make sure the handle is
loose.
• Guide the cut-out on the
lower section of the shaft
into the coupling‘s
locking plate on the
upper section of the
shaft. The sections are
then locked together.
• Tighten the handle.
Dismantling
• Undo the handle (at least
three turns).
• Press the handle towards
the coupling.
• Carefully twist the lower
section out of the lock.
• Hold both parts of the
shaft and pull out the
lower section from the
coupling.
Assembling and dismantling the
two-part shaft (225LD)
C
B
A