Filter
Top Products
English – 13
PRESENTATION
Cutting height adjustment lever
The cutting height can be adjusted to 10 different positions
with the cutting height lever.
Combi-unit 25-75 mm
Seat
The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
Loosen the handles under the seat and adjust it forwards or
backwards to the desired position.
Fueling
The engine runs on unleaded petrol with a minimum octane
rating of 85 (not mixed with oil). We recommend the use of
biodegradable alkylate petrol. Do not use petrol that contains
methanol.
Do not fill the tank completely, leave an expansion area of at
least 2.5 cm (1“).
Release lever Rider 213 C, Rider 216
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff. Pull the
controls to the end positions, do not use an intermediate
position.
• Pull out the control to disengage the drive system.
• Push in the control to engage to the drive system.
Release lever Rider 216 AWD
Rider 216 AWD has one control for the front axle and one
control for the rear axle.
Should you attempt to drive the machine with the clutch
controls pulled out it will not move. The drive on the axle is
disengaged when one of the controls is pulled out.
Clutch control, rear axle
• Control drawn out, drive system disengaged.
• Control depressed, drive system engaged.
Clutch control, front axle
The control is positioned on the inside of the left front wheel.
• Rear control (pulled out), drive system disengaged.
• Front control (pushed in), drive system engaged.
!
WARNING! Petrol is highly inflammable.
Exercise care and refuel outdoors (see
safety instructions).
IMPORTANT!
Do not use the fuel tank as a support area.
IMPORTANT!
Always drive the machine with both clutch controls pressed
in.