Husqvarna 2009-01 Blower User Manual


  Open as PDF
of 21
 
10
2. Install the bagger mount tube to the rear guard
with
5
/16-18x3¼boltsandangenutsfromkit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to
5
/16"ifkithardwareistoo
large.
3. Installkitsupportstrapsontheoutsideofthe
mount tube as shown in the illustration. Using a
5
/16-18 x 1¼ bolt, attach the front side of the strap
tothefendersupport.Donotaddangenutatthis
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
boltandfastenbothboltswithangenuts.Repeat
steps on opposite side.
NOTE:Thefrontsideofthekitsupportstraps
should be on the inside of the mower frame.
4. Tighten all hardware.
ASSEMBLY
1. To select the right support straps to use, measure
the mower frame just behind the casters, as
shown.
7
INSTALLING BAGGER MOUNT
Reinforcement Plate
Mount Tube
Support Strap
For frames measuring 26" use support straps A,
for frames measuring 23" use support straps B.
A
B
Drill rear
guard hole to
5
/16" if needed
Rear Guard
 previous next