Filter
Top Products
English – 19
Driving
Stop the engine
Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard. Avoid idling the engine for long periods, as
there is a risk of carbon build-up on the spark plugs.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 Move the throttle control to the MIN. position. Turn the
ignition key to the ”STOP”.
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
Release lever
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Pull the controls to the end positions, do not use an
intermediate position.
Release lever Rider 175 AWD
Rider 175 AWD has one control for the front axle and one
control for the rear axle.
• Clutch control, rear axle
- Control drawn out, drive system disengaged.
- Control depressed, drive system engaged.
• Clutch control, front axle
The control is positioned on the inside of the left front
wheel.
- Rear control (pulled out), drive system disengaged.
- Front control (pushed in), drive system engaged.
Release lever Rider 175
• Pull out the control to disengage the drive system.
• Push in the control to engage to the drive system.