Filter
Top Products
32 – English
MAINTENANCE
IMPORTANT INFORMATION
The blades on a BioClip unit should be
set at 90 degrees to each other. In all
other cases the blades can collide and
cause serious damage to the cutting unit.
Replacing the cutting unit belts
Belt replacement on BioClip 90
The BioClip 90 is driven by a toothed belt that
synchronises rotation of the blades. The belt is
located under the cover of the cutting unit.
When changing the belt on a BioClip 90 follow
steps 1-7 of the above procedure for version 2.
NOTE! BioClip 90 has just 1 belt.
Belt replacement on the Combi 103, 112 cutting
unit
On these cutting units with "collision-proof" blades,
the blades are driven by one V-belt. Do as follows to
change the V-belt:
1. Remove the cutting unit, see page 31.
2. Undo the bolt on the lift strut and the two screws
on the cover. Lift the cover off the cutting unit.
3. Loosen the spring that tensions the V-belt and
pry off the belt.
Simply reverse the procedure to fit the new belt.
6012-079
8009-287
6012-080