Filter
Top Products
ASSEMBLY
English – 13
and the cable position keep 1-2mm play between the
cable lug and the slotted fitting when the throttle
trigger is fully depressed.
7 When the throttle cable is adjusted correctly, tighten
the lock-nut (F) and the M3 screw (G).
8 Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is
not important.
9 Lap and fix the stop switch wires and connectors with
clamp (I).
10 Fit the dust cover (J).
11 Refit the air filter cover.
Fitting blades and trimmer heads
1-2mm
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.