Filter
Top Products
English – 13
ASSEMBLY
Fitting the guard extension
143R
CAUTION! The guard extension shall always be fitted when
using the trimmer head/plastic blades and combination
guard. The guard extension shall always be removed when
using the grass blade and combination guard.
Enter the guard extension guide in the slot of the combination
guard. Then click the guard extension into position on the
guard with the four quick-fasteners.
The guard extension is removed easily using the spark plug
spanner, see illustration.
Fitting the transport guard
1 Insert the tips of the blade into the grooves in the transport
guard (A).
2 Wind the transport guard around the teeth of the blade,
then clip the ends together (B).
Fitting a blade guard, grass blade
and grass cutter
• 132R: The blade guard (A) is fitted using 4 screws (L) as
shown. CAUTION! Use the recommended blade guard.
See the Technical data section.
133R: Hook the blade guard/combination guard (A) onto
the fitting on the shaft and secure with the bolt (L).
142R: Fit the guard (A) to the gear housing using the
support plate (M) and two screws (L).
CAUTION! Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical
data section.
143R: Hook the blade guard/combination guard (A) onto
the fitting on the shaft and secure with the bolt. CAUTION!
Ensure that the guard extension is removed. Use the
recommended blade guard. See the Technical data
section.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
A B
L
A
M
L
A
A