Husqvarna 1330SB Snow Blower User Manual


 
23
REPAIR PARTS AUGER HOUSING / IMPELLER ASSEMBLY
SNOW THROWER - MODEL NO.
1330SB
1330SB (96193004200), PRODUCT NO. 961 93 00-42
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
1 532 18 41-05 IMPELLER
2 532 19 67-10 GEARBOX ASSEMBLY
3 532 18 89-09 BEARING
4 532 42 70-71 IMPELLER PULLEY
5 532 17 53-22 DISCHARGE BASE
6 532 18 40-95 CORNER BRACKET
7 532 19 21-99 CLEAN OUT TOOL
8 532 40 54-00 TOOL CLIP
9 873 80 04-00 NUT 1/420
10 874 78 04-26 SCREW 1/420 X .625
11 532 42 79-42 NUT 5/1618
12 532 16 31-83 SCREW 5/1618 X .625
13 819 11 15-07 WASHER
14 810 04 05-00 LOCKWASHER 5/16
15 874 94 05-16 SCREW 5/1618 X 1.00
16 532 18 03-55 CARRIAGE BOLT
17 532 19 41-89 SCREW 1316 X .625
18 532 40 77-60 PLUG
19 532 40 77-61 GEARBOX COVER RH
20 532 40 77-66 GASKET
21 532 40 77-70 SEAL
22 532 40 77-62 BEARING
23 532 17 46-97 THRUST WASHER 1.00
24 532 40 77-63 WORM GEAR
25 532 40 77-64 AUGER SHAFT
26 532 18 92-82 SQUARE KEY
27 532 40 77-58 BEARING
28 532 17 46-83 THRUST WASHER
29 532 40 77-57 IMPELLER SHAFT
30 532 18 42-05 ROLL PIN
31 532 17 46-81 THRUST WASHER
32 532 17 46-84 THRUST BEARING
33 532 40 77-69 BEARING
34 532 40 77-68 ORING
35 532 40 77-67 SCREW 5/1618 X .750
36 532 40 77-65 GEARBOX COVER LH
37 532 19 20-90 BOLT
KEY PART
NO. NO. DESCRIPTION