Filter
Top Products
English
7
WARNING
Check to see if the shock-absorbing
rubber mount has become cracked or
otherwise damaged. Note that failing to
replace this rubber mount when it has
become cracked or damaged may
cause the engine to come loose from its
frame during use, thus resulting in
possible serious bodily injury.
If cracked, be sure to replace without delay.
WARNING
To reduce the risk of injury associated
with contacting rotating parts, stop the
engine before installing or removing
attachments.
Do not operate without
net in place.
Always disconnect the
spark plug before performing mainte-
nance or accessing movable parts.
USING THE PRODUCT
WARNING
While using the product, if abnormal noise or vibration
occurs, stop the engine immediately and contact the near-
est Husqvarna servicing dealer for assistance. Checking
the fan is very important. If the rotating fan should break up,
it will lead to serious accidents.
1. Check the work area that the blower will be used in and
remove or cover all valuables that may be damaged by the
air blast or thrown debris.
2. To reduce the risk of injury associated with thrown objects.
a)Watch out for children, pets, open windows or freshly
washed cars, and blow debris safely away.
b)Use the full blower tube extension so the air stream can
work close to the ground.
c) Do not allow bystanders in work area.
d)Do not point the blower
tube in the direction of
people or pets.
e)Always check to be sure
that no debris has been
blown onto someone
else’s property.
f) Pay attention to the
direction of the wind, do not work against the wind.
3. To minimize blowing time.
a)Use rakes and brooms to loosen debris before blowing.
b)In dusty conditions, slightly dampen surfaces or use a
mister attachment when water is available.
c) Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches and
gardens.
4. The blower must not be used while on
a ladder or scaffolding.
5. Never put the machine down with the
engine running unless you have it in
clear sight.
6. Never touch the spark plug or plug cord
while the engine is in operation. Doing
so may result in being subjected to an
electrical shock.
7. Never touch the muffler, spark plug, or
other metallic parts of the engine, or
area around the engine cover while the
engine is in operation or immediately
after shutting down the engine. These
metallic parts reach high temperatures
during operation and doing so could
result in serious burns.
WARNING
The temperature of the machine may
increase after stopping the engine.
Especially never forget to cool down
the engine before refueling the
machine.
8. After using blowers and other
equipment, CLEAN UP! Dispose of
debris in trash receptacles.
MAINTENANCE
1. In order to maintain your product in proper working order,
perform the maintenance and checking operations described
in the manual at regular intervals.
2. Always be sure to turn off the engine and disconnect the
spark plug before performing any maintenance or checking
procedures.
WARNING
The metallic parts, engine cover, and area around the
engine reach high temperatures immediately after stopping
the engine.
3. Examine the blower at intervals for loose fasteners and
rusted or damaged parts. Use special care around the fuel
line, the muffler, and the ignition wiring.
4. All engine service except for those described in this manual
should be performed by competent service personnel.
Improper service to the blower fan and muffler could cause a
hazardous failure.
5. When replacing the any other part or any lubricant, always be
sure to use only Husqvarna products or products which have
been certified by Husqvarna for use with the Husqvarna
product.
6. In the event that any part must be replaced or any
maintenance or repair work not described in this manual
must be performed, please contact the nearest Husqvarna
servicing dealer for assistance.
7. Do not use any accessory or attachment other than those
bearing the Husqvarna mark and recommended for the unit.
8. Under no circumstances should you ever take apart the
product or alter it in any way. Doing so might result in the
product becoming damaged during operation or the product
becoming unable to operate properly.
TRANSPORTATION
• Drain the fuel from the fuel tank before transporting or storing
the blower.
• Secure the blower so that it does nor receive damage from
shock doing transportation.
• Do not apply strong forces to the blower, such as throwing it or
dropping it. Doing so in validates the warranty.
STORAGE
• When storing the blower, choose a space indoors free from
moisture and out of the reach of children.
Safety Precautions