Filter
Top Products
English – 13
STARTING AND STOPPING
Starting and stopping
Cold engine
Ignition:
Set the stop switch to the start position.
Choke: Set the choke control in the choke position.
Air purge: Press the air purge diaphragm repeatedly until fuel
begins to fill the diaphragm. The diaphragm need not be
completely filled.
Warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
Starting
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!).
Grip the starter handle, slowly pull out the cord with your right
hand until you feel some resistance (the starter pawls grip),
now quickly and powerfully pull the cord.
Reset the choke when the engine fires, repeat pulling the cord
until the engine starts. Never twist the starter cord around
your hand.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
Stopping
The engine is stopped by moving the stop switch to the stop
position.
!
WARNING! Always move the machine away
from the refuelling area before starting.
Place the machine on a flat surface.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury. The safety distance
is 10 metres.
The machine may only be started in its
complete design. If the machine is started
without all the guards fitted there is a risk of
personal injuries.