Filter
Top Products
English
21
■
COOLING SYSTEM
- To keep the working temperature as low as possible the machine is
equipped with a cooling system.
(1) Cooling fins on the cylinder.
Clean the cooling system with a brush once a week, more often in
demanding conditions. A dirty or blocked cooling system results in the machine
overheating which causes damage to the piston and cylinder.
■
AIR INLET NET
IMPORTANT
- Blown air is taken in from the air inlet net. If the air flow drops during
operation, stop the engine and inspect the air inlet net for blockage by
obstacles.
- Note that failure to remove any such obstacles may result in the engine
becoming overheated and damaged.
(1)Net
WARNING
Never use the blower without the net on the blower. Before each use,
check that the net is attached in place and is free from any damage.
■
SHOLDER STRAP
- If the shoulder strap is damaged it may break during use, thus causing the
product to fall and resulting in personal injury. Follow the instructions below
to replace the shoulder strap with new one.
- Take off the clip from the strap.
- Pass the end of the strap through the hanger.
- Return the clip to the strap.
IMPORTANT
Make sure that the thick round bar of the clip is in the strap.
If it is attached in the wrong way, it leads to serious personal injury.
BEFORE STORING THE BLOWER:
1. Drain the fuel tank and push the primer bulb until it becomes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and install
the spark plug.
3. Store unit in a dry, cool and dark, well-ventilated, dust-free place, out of the reach of children.
Storage
(1)
(1)
(1)
F38
F37
[130BT]
[350BT/BF] [370BTS/BFS] [380BTS/BFS]
F36
F39
Maintenance
H1153190-95US.fm Page 21 Tuesday, December 15, 2009 9:05 AM