Filter
Top Products
8
ASSEMBLY
Frame Bracket
Hanger
Cover Assembly
1
INSTALL PLATE AND HANGER
2
MOUNTING COVER ASSEMBLY
TO SUPPORT ASSEMBLY
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
Position cover assembly on the ground behind the 1.
mower.
Lift and rotate cover to align the frame bracket 2.
with the hanger and slide the cover down until
secure.
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet. Replace the plastic end cap back over
the spacer. The additional extension will hold the
hood more securely when latched.
3
INSTALLING SPACER PLUG
Using hardware provided in kit, attach support 1.
mount to unit.
Attach hanger bracket to support mount. Do not 2.
fully tighten nuts at this time.
Secure rear end of support straps to outside of 3.
hanger assembly. Set reinforcement plates to the
outside of the tank brackets and fasten front end
of support strap to tank bracket and reinforcment
plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Dependingonmodel,rearguardholemay
needtobedrilledoutto
5
/16"ifkithardwareistoo
large.
Remove center
end cap
Insert spacer and
replace cap
Support Straps
Reinforcement Plate
Round Head
Bolt Placement
Hex Bolt Placement
Hanger Bracket
Support Mount