Filter
Top Products
40 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
The Husqvarna 395XP is in the ANSI category of saws above 3,8 cu. in. and is not required to comply with low kickback
performance requirements. However, for this model we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
18 3/8
0,058
11T
Husqvarna H42,
Husqvarna H48
68
20 3/8 11T 72
24 3/8 11T 84
28 3/8 11T 93
0,050"/1,3 mm H46 H47
0,058"/1,5 mm H42 H48
0,063"/1,6 mm H45 H50
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.