Filter
Top Products
40 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting
equipment.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
15 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
56
16 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
60
18 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
68
20 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
72
24 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
84
28 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
93
0,050"/1,3 mm H46 H47
0,058"/1,5 mm H42 H48
!
WARNING! This chain saw model is
capable of severe kickback that could
result in serious injuries to the user. Do
not operate this saw unless you have
extraordinary cutting needs and
experience and specialized training for
dealing with kickback. Saws with
significantly reduced kickback potential
are available. Always use the safest saw
and cutting equipment applicable to your
cutting need.