Filter
Top Products
28 – English
Replacement of the oil filter
1. Dismantle the engine hood as described on
page 18.
2. Drain off the engine oil according to the work
description “Changing of engine oil” on page 27.
3. Dismantle the oil filter. If necessary use a filter
extractor.
4. Apply new, clean engine oil on the seal for the
new filter.
5. Fit the filter and tighten by hand.
6. Run the engine warm and check that there is no
leakage round the oil filter seal.
Lubrication
The following three lubrication points shall be
lubricated regularly with graphite grease of good
quality.
In the event of daily use lubrication should be
conducted twice a week.
General lubrication
All joints and bearings are lubricated on
manufacture with molybdenum sulphide grease.
Re-grease with same type of grease.
Lubricate the steering and control wires with engine
oil.
Conduct this lubrication regularly: during daily use
of the machine it should be lubricated twice a week.
MAINTENANCE