Hunter Fan 42027-01 Outdoor Ceiling Fan User Manual


 
10
Hunter Fan Company 42027-01 • 12/09/05
11
42027-01 • 12/09/05 Hunter Fan Company
7 • Completing Your Installation With or Without a Light Fixture
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are rmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8” screw into the housing. Tighten
all three screws rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light xture falling.
Your Hunter fan comes with an integrated light xture assembly and an
optional switch housing cap and plug button. is feature gives you the
option of installing the fan with OR without the included light xture.
If you want to install the light xture, proceed with step 7-5 now.
If you do not want to install the light xture, you need to uninstall it
now. See “Uninstalling the Light Fixture” on page 14.
WARNING: Use only the light xture supplied with this fan model.
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
Step 7-4