Filter
Top Products
Steps
1. Disconnect power to the ceiling fan by turning o the circuit breakers to both the outlet box
and to its associated wall switch location.
2. Remove the lower switch housing from the fan and remove the cover. (see gure 1)
3. Locate the black wire with a white stripe and the white wire in the lower switch housing. Using
approved wire nut connectors, connect the black wire with a white stripe from the lower switch
housing to the black wire from the light kit, then connect the white wire from the lower switch
housing to the white wire from the light kit. (see gure 2)
4. Align the holes in the lower switch housing with the two partially installed screws in the top of
the light kit. ese screws can be accessed through the two holes in the metal plate which sits
below the light socket. (see gure 2)
5. Attach the light kit to the lower switch housing by securely tightening the two partially installed
screws. Reinstall the lower switch housing. WARNING: Improper installation could cause the
light xture to fall.
6. Install one 75 Watt max A-19 bulb into the light socket.
7. Align the four holes in the upper louver ring with the four holes in the lower louver ring. When
the holes are properly aligned, the two rings will loosely lock together. (see gure 3)
gure 2
access
holes
partially installed
screw
gure 3
upper louver
ring
lower louver
ring
gure 1
cover
lower switch
housing
lower switch
housing
41370-01 rev 7-28-05.indd 7/28/2005, 11:38 AM3