Filter
Top Products
MAINTENANCE
42 - Husqvarna
IMPORTANT INFORMATION
The end cover must be installed with the
rubber valve pointing downwards or the
rubber valve will not function.
Pull the main lter (outer) lter out.1.
Remove the inner lter.2.
Clean inside the lter housing, cover housing 3.
and dust cap. Wipe dry only.
Reinstall or replace the inner lter with the 4.
open end rst, ensuring that it enters the
housing recess. Push in to the end.
Reinstall or replace the outer lter with the 5.
open end rst so that it enters the recess. Push
in to the end.
Replace the end cover with the rubber valve 6.
pointing downwards and secure retaining clips.
8011-449
Removing the main lter
8011-450
Removing the inner lter
Engine Oil Cooler
Clean the outside of ns with a brush.1.
Remove the two screws holding the cooler unit 2.
to the blower housing.
Tilt the cooler downward.3.
Clean the inside of the cooler with a brush or 4.
with compressed air.
Reinstall the oil cooler to the blower housing.5.
8011-472
Engine oil cooler