Filter
Top Products
7
To access UV mode from the main unit press UP or DOWN until the UV icon
on
the display will flash. From the handheld remote control: Press
.
Viewing UV Statistics
In UV Mode press the MEMORY button viewing either current UV intensity, daily
Maximum UV intensity with “DAILY MAX” displayed or weekly Maximum UV
intensity with a “WEEKLY MAX” displayed.
Resetting the UV Statistics Memory
In UV Mode, press and hold MEMORY button to reset all UV statistics.
Setting Units for UV Display (MED/h or UVI)
In UV Mode, press and hold SET to convert units between MED/h and UVI.
Maintenance
Changing Batteries
The battery status of the remote UV sensor is checked every hour by the main unit. If the
low battery indicator in the display section for UV data lights up, replace the batteries in
the remote UV sensor.
When the batteries are properly installed, the remote UV sensor will resume sending
signals to the main unit.
To enforce an immediate remote signals search, press and hold DOWN button on the
main unit.
Cleaning
The outer casing of the remote UV sensor can be cleaned with a damp cloth. Small parts
can be cleaned with a cotton tip or pipe-cleaner.
Never use any abrasive cleaning agents and solvents. Do not immerse units with
electronic parts in water or under running water.