Filter
Top Products
5
5
D. WALL-MOUNT RECESSED HOLE
• Keeps the remote sensor on the wall
E. °C/ °F SWITCH
• Selects the temperature display in Celsius or Fahrenheit
TS03 SENSOR IS COMPATIBLE WITH ALL HONEYWELL
WIRELESS WEATHER STATIONS
BEFORE YOU BEGIN
• The remote sensor can be placed indoors or outdoors.
• We recommend using alkaline batteries for the remote sensor
when temperatures are above 32°F (0°C). We recommend using
AA lithium batteries when temperatures are below 32°F (0°C).
• Avoid using rechargeable batteries. (Rechargeable batteries
cannot maintain correct power requirements).
• Insert batteries before first use, matching the polarity in the
battery compartment.
• ALWAYS install batteries in the remote sensor before the main
unit.
• Press RESET after each battery change with a paper clip or
similar tool.
• During an initial setup, place the main unit as close as possible
to the remote sensor.
• After reception is established (the remote temperature will
appear on the main unit’s display), position the remote sensor
and the main unit within the effective transmission range of 100
feet (30 meters).
6
NOTE:
1. Avoid setting manually the time and date on the main unit before the
remote temperature is displayed.
2. The effective operating range may be influenced by the surrounding
building materials and how the receiver (main unit) and transmitter
(remote sensor) are positioned.
3. Place the remote sensor so that it faces the main unit (receiver),
minimizing obstructions such as doors, walls, and furniture.
4. Though the remote sensors are weather-resistant, they should be
placed away from direct sunlight, rain or snow.
NOTE:
When the temperature falls below freezing, the batteries in
the outdoor remote sensors may have reduced voltage supply and a
shorter effective range. We recommend using lithium batteries at
temperature 32°F (0°C) and below.
BATTERY INSTALLATION
NOTE: Install the batteries; select the channel (if available) and
temperature in C° or F° before mounting the remote sensor.
• Remove the screws from the battery compartment with a small
Phillips screwdriver.
• Set the channel (if channel switch is available in your model).
The switch is located in the battery compartment. Channel 1 is
typically selected if only one remote sensor is being used.
• Install 2 “AA” size alkaline batteries (not included) matching
the polarities shown in the battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure remote sensor in the desired location.