Filter
Top Products
7
7
B. BATTERY COMPARTMENT
• Holds two AA-size batteries
C. RESET
• Resets all previous settings
D. CHANNEL SWITCH
• Selects the desired channel -1,2 or 3
E. WALL-MOUNT RECESSED OPENING
• Keeps the remote sensor on the wall
F. °C/°F SWITCH
• Selects the temperature display in Fahrenheit or Celsius
NOTE: Install the batteries; select the channel and temperature in °C or °F
before mounting the sensor.
BATTERY INSTALLATION
• Remove the screws from the battery compartment with a small Phillips
screwdriver.
• Set the channel 1 through 3. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote sensor
is being used.
• Install 2 “AA” size alkaline batteries (not included) matching the
polarities shown in the battery compartment.
• Select the temperature unit in °F or °C by pressing °C/°F switch with a
paper clip or similar tool
• Replace the battery compartment door and secure the screws.
• Secure the remote sensor in the desired location.
MOUNTING
• The remote thermo-hygrometer sensor can be placed on the flat
surface or mounted on the wall in vertical position
8
• Use the wall mount hardware and screws when mounting the
thermo-hygrometer sensor on the wall
PLACEMENT
• The remote thermo-hygrometer sensor should be placed in the area
with a free air circulation and sheltered from the direct sunlight and an
extreme weather conditions.
• Ideally, place the thermo-hygrometer sensor above the natural surfaces
(such as a grassy lawn).
• Avoid placing the thermo-hygrometer sensor near sources of heat,
such as chimneys and heating elements.
• Avoid any areas collecting and radiating a heat from the sun, such as
metal, brick or concrete structures, paving, patios and decks.
• The international standard for the valid air temperature measurements
is 4 feet (1.25meters) above the ground.
OPERATION
Immediately after batteries are correctly installed, the remote sensor will start
transmitting a temperature and humidity data to the main unit.
WIND SPEED METER
FEATURES
• Wind speed and wind gust measurement
• Measurement of the temperature at the place of the wind meter
• Remote transmission of the temperature, wind speed and gust data to
the main unit via 433 MHz signal
• Operating range of up to 100 feet (30 meters)
• Wall or pole mount