Filter
Top Products
Page 7
FEATURES
INSTRUCTIONS
When unpacking the blower:
■ Carefully remove the blower and accessories from the box.
■ Make sure that all items listed in the packing list are in-
cluded.
■ Inspect the blower carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the blower.
■ If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
WARNING:
If any parts are missing do not operate the blower until the
missing parts are replaced. Failure to do so could result in
possible serious personal injury.
PACKING LIST
Blower
Upper Blower Tube
Wide Sweeper Nozzle
Tube Clamp
Operator's Manual
NOTE: Read and remove all hang tags and store with your
operator's manual.
WARNING:
Stop the engine and disconnect the spark plug wire before
installing parts, making adjustments, cleaning, or when
not in use. Failure to do so could result in possible serious
personal injury.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
1. Screw the nozzle onto the upper blower tube and tighten
securely. Check tightness after initial run and retighten if
needed.
2. Place clamp around the neck of the blower housing
outlet. Do not tighten the wing nut yet.
3. Align the locking tab on upper blower tube with the slot
in the blower housing outlet; push the tube into the
housing. Twist to lock into place.
4. Rotate the tube so the nozzle is pointing upward as
shown. Tighten the wing nut securely.
See Figure 2.
5. To remove the tubes, loosen the wing nut on the clamp.
Rotate the tubes to unlock them remove from the blower
housing outlet.
Fig. 2
ASSEMBLY
NOZZLE
UPPER TUBE
WING NUT