Filter
Top Products
29
SAFE-T-TIP® NOSE GUARD MAINTE-
NANCE
See Figures 42 and 43.
Tighten the mounting screw of the nose guard as
instructed below. These are specially hardened
screws. If the screw cannot be installed tightly, replace
both the screw and the SAFE-T-TIP® before further
operation. Do not replace with an ordinary screw.
In addition to preventing chain contact with solid
objects at the nose of the bar, the SAFE-T-TIP® also
helps keep the chain away from abrasive surfaces
such as the ground. Keep it on the right hand side of
the bar, where it will be between the chain and the
ground during flush with ground cutting.
The mounting screw requires a 5/16 in. wrench (or
adjustable wrench) to achieve the recommended
tightness of 35 to 45 in. lb. (4-5 Nm). A tightness
within this range can be achieved by the following
method.
1. Tighten the screw with your finger.
2. From the finger-tight position, tighten the screw an
additional 3/4 of a turn using a wrench.
MOUNTING SAFE-T-TIP® NOSE GUARD
See Figuress 42 and 43.
1 Mount the SAFE-T-TIP® on the bar nose.
NOTE: The tab fits in the recessed hole in the bar.
2. Tighten the screw with your finger.
3. From the finger-tight position, tighten the screw an
additional 3/4 of a turn using a wrench.
WARNING:
Although the guide bar comes with a SAFE-T-
TIP® anti-kickback device already installed, you
need to check the tightness of the mounting
screw before each use.
TIGHTEN 3/4
OF A TURN
MOUNTING SCREW
SAFE-T-TIP
LOCKING RIVET
CAUTION:
Remove the battery pack and make sure the
chain has stopped before you do any work on
the saw.
Fig. 42
Fig. 43
MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.
come in contact with plastic parts. They contain
chemicals that can damage, weaken or destroy
plastic.
WARNING:
When servicing use only identical Homelite
replacement parts. Use of any other parts may
create a hazard or cause product damage.