Filter
Top Products
Page 8
ASSEMBLED
EDGER GUIDE
TABS
GRASS DEFLECTOR WITH EDGER GUIDE -
TRIM ‘N EDGE ONLY (Continued)
See Figures 5 and 6.
1. Remove the wing nut, flat washer, lock washer, and bolt
from the Owner’s Kit.
2. Place the grass deflector over the shaft and bracket.
3. Slide the assembled edger guide over the tabs on the
grass deflector and bracket.
4. Place the bolt through the slots in the tabs on the grass
deflector and trimmer.
NOTE: Ensure the slots are aligned before installing the
bolt.
5. Install the flat washer, lock washer and wing nut.
6. Tighten the wing nut securely.
GRASS DEFLECTOR - EASY REACH
See Figure 7.
1. Remove the wing nut from the Owner's Kit.
2. Place slot in grass deflector over the square tab of the
mounting bracket.
3. Rotate the deflector around the drive shaft housing then
insert the screw on the grass deflector into the screw
hole in the mounting bracket. The mounting surface of
the grass deflector should fit flush on the mounting
bracket.
4. Install the wing nut and tighten securely.
FLAT
WASHER
LOCK
WASHER
WING NUT
LONG BOLT
Fig. 6
WING NUT
GRASS
DEFLECTOR
SLOT
SCREW
SQUARE TAB
Fig. 7
Fig. 5
ASSEMBLY