Filter
Top Products
Page 15
S
T
S
T
O
P
O
P
A
B
C
Fig. 12
THROTTLE
TRIGGER
PRIMER BULB
OPERATION
STARTING
INSTRUCTION
LABEL
STOP
STOP
A
B
C
STARTING AND STOPPING
See Figures 12 and 13.
Trimmer should be on a flat, bare surface for starting.
1. Slowly press the primer bulb seven (7) times.
2. Set the choke lever to the FULL CHOKE position (A).
3. Squeeze the throttle trigger fully and pull starter handle
sharply until engine attempts to run. Do not pull the
starter handle more than eight (8) times.
NOTE: Keep throttle trigger squeezed fully through
STEP 6.
4. Set the choke lever to the HALF CHOKE position (B).
5. Pull the starter handle until the engine runs. Do not pull
the starter handle more than six (6) times.
6. Allow the engine to run for 15 seconds, then set the
choke lever to the RUN position (C).
TO STOP THE ENGINE:
See Figure 13.
To stop the engine, push and hold the STOP button until the
engine stops.
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-242-4672
PRIMER BULB
CHOKE LEVER
STOP BUTTON
Fig. 13
FULL
CHOKE
(A)
HALF
CHOKE
(B)
RUN (C)