Filter
Top Products
Page 22 — English
OPERATION
BUCKING
See Figure 26.
Bucking is the term used for cutting a fallen tree
to the desired log length.
Cut only one log at a time.
Support small logs on a saw horse or another
log while bucking.
Keepaclearcuttingarea.Makesurethatno
objects can contact the guide bar nose and
chain during cutting, this can cause kickback.
To avoid the danger, keep the SAFE-T-TIP
®
anti-kickback device attached while cutting.
Refer to Kickback in the Specific Safety Rules
section of this manual for more information.
During bucking operations, stand on the uphill
side so that the cut-off section of the log cannot
roll over you.
Sometimes it is impossible to avoid pinching
(with just standard cutting techniques) or dif-
ficult to predict which way a log will settle when
cut.
BUCKING WITH A WEDGE
See Figure 27.
If the wood diameter is large enough for you to
insert a soft bucking wedge without touching the
chain, you should use the wedge to hold the cut
open to prevent pinching.
NOTE: When bucking or felling with a wedge, you
may need to remove the SAFE-T-TIP
®
anti-kickback
device to allow the bar to be drawn through the
cut. After you complete the cut, reinstall the tip.
WEDGE
Fig. 27
KICKBACK
Fig. 26